Starting Up; Powering Up; Standby/On) Switch; Dc In Terminal - Yamaha PSR-A2000 Owner's Manual

Starting Up

Powering Up

Power supply
1
Make sure that the instrument's [
to Standby (off).
2
Connect one end of the AC cable to the power adaptor.
3
Connect the power adaptor's DC plug to the instrument's DC IN
terminal on the rear panel.
4
Connect the other end (normal AC plug) to the nearest electrical
outlet.
Turning the Power On
Before you switch the instrument on or off, first turn down the volume of any
connected audio equipment.
1
Press the [

] (Standby/On) switch.

The main display appears in the display.
1
14
PSR-A2000 Owner's Manual
] (Standby/On) switch is set
WARNING
Use the specified adaptor
(page 197) only.
The use of an incompatible
adaptor may cause irreparable
damage to the PSR-A2000, and
may even pose a serious shock
hazard! ALWAYS UNPLUG THE
AC ADAPTOR FROM THE AC
POWER OUTLET WHEN THE
PSR-A2000 IS NOT IN USE.
CAUTION
Even when the switch is in the
standby position, electricity is
still flowing to the instrument at
a minimum level. When not
using the instrument for an
extended period of time, be
sure to unplug the AC power
adaptor from the wall AC outlet.
NOTICE
Never interrupt the power sup-
ply (e.g. unplug the AC adaptor)
during any PSR-A2000 record
operation! Doing so can result
in a loss of data.
NOTICE
In order to avoid possible dam-
age to the speakers or other
connected electronic equip-
ment, always switch on the
power of the PSR-A2000 before
switching on the power of the
amplified speakers or mixer and
amplifier. Likewise, always
switch off the power of the PSR-
A2000 after switching off the
power of the amplified speak-
ers or mixer and amplifier.
NOTE
Remove the transparent protective
film that was applied to the display
prior to shipment from the factory.