Drive Unit Characteristics; Heating Value - Mitsubishi Electric MELDAS MDS-R Series Technical Specification And Instruction Manual

3-1 Drive unit characteristics

3-1-1 Heating value

The heating value of each servo drive unit is the heating value at stall output.
Servo drive unit type
MDS-R-
V1-20
V1-40
V1-60
V1-80
POINT
Calculation example: When using MDS-R-V1-20 and MDS-R-V2-2020
Total heating value = (15 + 31) + (26 + 63) = 135 [W]
Heating value in panel = 15 x 0.5 + 26 x 0.5 = 20.5 [W]
3. Characteristics
Heating value [W]
Inside Outside
panel panel
15 31
21 52
27 74
36 105
Design the panel's heating value taking the actual axis operation (load rate) into
consideration. With a general machine tool, the servo drive unit's load rate is
approx. 50%, so the heating values inside the panel are half the values shown
above.
Servo drive unit type
MDS-R-
V2-2020
V2-4020
V2-4040
V2-6040
V2-6060
V2-8040
V2-8060
V2-8080
3 - 2
Heating value [W]
Inside Outside
panel panel
26 63
32 83
38 105
45 125
50 150
53 158
60 180
68 210