Table of Contents
Advertisement
DOK-INDRV*-CXX02******-PR03-EN-P
IndraDrive Control Sections CSB02, CSE02, CSH02, CDB02
HIPERFACE® (12 V supply voltage)
Connection diagram
Power supply
Cable length
See the connection diagram for how to connect the encoder system.
1)
Line cross section ≥ 0.5 mm²; observe allowed encoder cable
length
2)
Line cross section ≥ 0.14 mm²
Fig. 8-3:
HIPERFACE® encoder system connection diagram
The HIPERFACE® encoder system requires a 12 V supply voltage. This sup‐
ply voltage is made available via the EC interface.
Technical specification of the power supply: See
on page 92
Observe that the third-party encoder used must be suited for the
voltage available at the EC interface as the encoder supply volt‐
age.
The maximum possible cable length depends on several factors: See
8.1.4 "Encoder cable length" on page 94
Bosch Rexroth AG
81/143
Technical data - functions
chapter "12 V power supply"
chapter
Advertisement
Table of Contents
