AEG AGN6500 Original Instructions Manual page 6

Do not connect to a building's electrical system unless a
transfer switch has been properly installed by a qualified
electrician.
Do not allow the generator's fuel tank to overflow when
filling. Fill to 25 mm below the top neck of the unleaded fuel
tank to allow for fuel expansion. Check the ventilation hole
inside the fuel tank cap for debris. Do not block the vent.
Do not smoke when filling the generator with unleaded fuel.
Allow the engine to remain in a shut-down condition for at
least five minutes before adding unleaded fuel or oil.
Do not remove the oil dipstick or the fuel tank cap when the
engine is running.
Pay close attention to all safety labels located on the
generator.
Keep children a minimum of 3 m (10 ft.) away from the
generator at all times.
The unit operates best in temperatures between 5°C and
40°C with a relative humidity of 30~95%.
Do not operate the generator at altitudes above 1,000 m.
When using extension lines or mobile distribution networks
the total length of lines for a cross section of 1.5 mm
should not exceed 60 m; for a cross section of 2.5 mm
this should not exceed 100 m.
The generating set must not be connected to other power
sources.
Save these instructions. Refer to them frequently and use
them to instruct others who may use this tool. If you loan
someone this tool, loan them these instructions also.
SERVICE
Servicing requires extreme care and knowledge and should be
performed only by a qualified service technician. For service,
contact your nearest authorised service centre for repair. When
servicing, use only identical replacement parts.
WARNING:
Observe all normal safety precautions to avoid electrical
shock.
DANGER:
To avoid death or serious personal injury, do not attempt
to operate this product until you read thoroughly and
understand completely the operator's manual. If you
do not understand the warnings and instructions in the
operator's manual, do not use this product. Call your
nearest authorised service centre for assistance.
WARNING:
The operation of any products can result in foreign
objects being thrown into your eyes, which can result
in severe eye damage. Before beginning power tool
operation, always wear safety goggles or safety glasses
with side shields and, when needed, a full face shield.
We recommend Wide Vision Safety Mask for use over
eyeglasses or standard safety glasses with side shields.
Always wear eye protection.
Save these instructions
6
SYMBOLS
Some of the following symbols may be used on this tool. Please
study them and learn their meaning. Proper interpretation of
these symbols will allow you to operate the tool better and
safer.
SYMBOL DESIGNATION/EXPLANATION
V Voltage
A Current
Hz Frequency (cycles per second)
W Power
hrs Time
litre Volume
ml Volume
2
2
cc Volume
Do not expose to rain or use in damp
locations.
To reduce the risk of injury, the user
must read and understand the operator's
manual before using this product.
Always wear safety goggles or safety
glasses with side shields and, as
necessary, a full face shield and hearing
protection when operating this product.
Precautions that involve your safety.
Failure to use in dry conditions and to
observe safe practices can result in
electric shock.
Running the generator gives off carbon
monoxide, an odorless, colorless, poison
gas. Breathing carbon monoxide can
cause nausea, fainting, or death.
Fuel and its vapours are extremely
flammable and explosive. Fire or
explosion can cause severe burns or
death.
To reduce the risk of injury or damage,
avoid contact with any hot surface.
Beware of electric shock level.
Fuel and its vapors are explosive and can
cause severe burns or death.
Consult with local electrician to
determine grounding requirements
before operation.
Add lubricant to full mark to start. Engine
will not start or will shut off if lubricant
is too low.
6