Canon imageFORMULA P-208 Service Manual With Parts Catalog page 50

CHAPTER 3 DISASSEMBLY & REASSEMBLY
Notes on assembling
1) First, assemble the top cover (base)
that it goes under the fitting parts
top cover and secure it with two screws
(self-tapping, BH M2.5x6). Then install the
spring in the hole
Figure 3-214
2) Assemble the follower roller (with a bear-
ing) and the one-way clutch.
Figure 3-215
Note: Install the follower roller so that the side
with the bearing
3-8
2
1 of the
4 in the top cover B.
faces outward.
1
COPYRIGHT © CANON ELECTRONICS INC. 2012
3) Insert the one-way clutch fitting part
so into the hole
Insert the end
3 the top cover (base).
4) Install the spring
follower roller (with a coil spring)
shaft.
Note: When passing the shaft, install the
follower roller so that the side with the
coil spring
outward.
2 in the document pressure.
3 into the square hole of
Figure 3-216
and unit
1 2
Figure 3-217
of the follower roller faces
1
Figure 3-218
CANON P-208 FIRST EDITION
1
and the
on the
3