Advertisement
4. Unplug the two cables from the display (indicated with yellow arrows)
5. Remove the (2) short screws behind the screen (indicated with red arrows)
6. Remove the (4) screws of the capacitor/PCB bracket (indicated with red)
7. Unplug the 2 pin and 3 pin Molex connectors from the PCB (not indicated – see
step 19 for picture of these connectors)
8. You can lift out the felt rings (indicated with white arrows), or leave them in place.
www.baratza.com
support@baratza.com
rev. 9/12/2018
Advertisement
