Advertisement
16. Put the silver front case back in position and check that no wires are pinched.
Install the (2) screws under the front feet, and insert the front feet. Continue to
follow these instructions before installing more screws.
17. Route the brown and black interlock switch wires and green display wire (*which
is only on the 270Wi) exactly as shown below.
Route wires to the
outside of the studs
2 pin Molex
connector plugged in
18. Plug both of the Molex connectors into the PCB, it is much easier to do it before
installing the capacitor/PCB bracket
19. Place the capacitor/PCB bracket in position and inspect wires for routing issues
20. Install (10) screws in back of grinder (reference step 9, will need to slightly lift
capacitor/PCB bracket to access top 2 screws)
www.baratza.com
support@baratza.com
Route wires to the
outside of the studs
3 pin Molex
connector plugged in
The capacitor/PCB bracket is removed in this
photo and is being held vertically
rev. 9/12/2018
Advertisement
