Pre-Operation Inspection - RIDGID SeeSnake CS6x Versa Operator's Manual

Pre-Operation Inspection

To reduce the risk of serious injury from electrical shock
or other causes, and to prevent damage to your equip-
ment, inspect all equipment and correct any problems
before each use.
To inspect all equipment, follow these steps:
1. Power off your equipment.
2. Disconnect and inspect all cords, cables, and connec-
tors for damage or modification.
3. Clean any dirt, oil, or other contamination from your
equipment to ease inspection and to prevent it from
slipping from your grip during transportation or use.
4. Inspect your equipment for any broken, worn, miss-
ing, misaligned, or binding parts, or any other condition
which might prevent safe, normal operation.
5. Refer to the instructions for all other equipment to in-
spect and make sure it is in good, usable condition.
6. Check your work area for the following:
• Adequate lighting.
• The presence of flammable liquids, vapors, or dust
that may ignite. If present, do not work in area until
sources have been identified and corrected. The
equipment is not explosion proof. Electrical connec-
tions can cause sparks.
• A clear, level, stable, and dry place for the operator.
Do not use the equipment while standing in water.
7. Examine the job to be done and determine the correct
equipment for the task.
8. Observe the work area and erect barriers as neces-
sary to keep bystanders away.
See additional product specific safety information and
warnings starting on page 10.
6 – English – CS6x Versa
1.800.561.8187
WARNING
www.
information@itm.com
.com