Table of Contents
Advertisement
To change the language setting, select Language under User Customize and press ENTER.
User Customize
Language
Beep Menu
Select the applicable language from the list, then press ENTER to save or ESC to cancel.
14.3.2 - Beep Menu
There are three types of audio notifications (beeps) that you can configure in the Beep Menu. When you are using the
MVCI CM Update, keep these beep notifications enabled:
•
CMU Notice - The MVCI indicates when the CM reprogramming is complete.
•
Low Voltage - The MVCI indicates that it has disconnected from the DLC and the vehicle battery state-of-charge is
low.
To change the beep settings, select Beep Menu under User Customize.
Select Beep Menu on the User Customize screen, and then press ENTER.
Highlight Key Beep and press ENTER to change the setting.
User Customize
Language
Beep Menu
Enable is the default setting for each beep type.
•
Press ENTER under a selected menu to change the settings as desired.
NOTE: Change only the Key beep under the Beep Menu.
Select the applicable setting from the list, then press ENTER to save or ESC to cancel.
Beep Menu
Key beep:
Low Voltage:
CMU Notice:
14.4 - MVCI Status
From the User Config menu, select System Status and press ENTER.
These status options are available:
•
SDIO-1
•
SDIO-2
•
Battery Charger
•
Host Status
14.4.1 - SDIO-1
The SDIO-1 slot has the SD memory card inserted. It holds all the calibration files needed for updating control
modules/units.
Page 18
Enable
Enable
Enable
v2.1
Advertisement
Table of Contents
