Cisco 730 Manual page 7

Your Headset
Note You can't install firmware updates to your headset through the USB Adapter.
Procedure
Step 1 Plug in your USB Adapter to your preferred device.
Step 2
Turn on your Cisco Headset 730.
Step 3 On your device, select Cisco HS USB Adapter from the Bluetooth device list.
Pair the USB Adapter to Your Headset
You can re-pair your USB Adapter if you have erased your headset Bluetooth pairings or need to replace your
adapter.
Procedure
Step 1 Connect the USB Adapter to your chosen device.
Step 2
Use a pen or a paper clip to press down the Pairing button on the USB Adapter for four seconds. The blue
LED on top of the adapter blinks when it enters pairing mode.
Step 3 On your headset, slide and hold the Power/Bluetooth switch for two seconds. The adapter and your headset
pair automatically. The LED on top of the adapter shows solid blue when it connects.
Table 2: USB Adapter LED Status
USB LED
The LED shows solid
blue.
The LED flashes blue.
The LED flashes for 10
seconds and turns off.
Adapter Status
The USB Adapter is connected to the headset.
The USB Adapter is in pairing mode.
The USB Adapter can't find a saved headset. Your headset automatically pairs
to the adapter when it turns on and has less than two active Bluetooth connections.
If you have erased all Bluetooth pairings from your headset, put the adapter and
your headset into pairing mode to reconnect them.
Pair the USB Adapter to Your Headset
Your Headset
7