GE H
EALTHCARE
D
2307224-100, R
IRECTION
EVISION
8.) Refer to
Elevator/Tilt Drive Assembly cover into place.
9.) Set the cover and hardware aside.
6.2.4.2
Remove the Base Cover Brackets
Refer to
1.) Use a 5 mm Allen wrench to remove the two M6 socket-head cap screws that fasten each of
the cover brackets (total of 4, one in each corner) to the ETC chassis.
2.) Follow local guidelines to recycle or discard the brackets.
Page 118
6
Figure
6-7. Use a 1/8 inch Allen wrench to remove the four screws that fasten the
Screws (4) on Elevator/Tilt Drive Assembly
Figure 6-7: Table Elevator/Tilt Drive Assembly
Figure
6-8. Remove the four cover brackets from the ETC chassis.
Each bracket held in place with two sets of M6 hardware.
Figure 6-8: Remove Cover Brackets from ETC chassis
Chapter 6 - Table
D
LS S
S
ISCOVERY
YSTEM
ERVICE
M
ANUAL