Adjust - Canon imageRUNNER ADVANCE 4551i Service Manual

Address
5
4
3
2
1
0

ADJUST

■ AE
COPIER > ADJUST > AE
AE-TBL 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
■ ADJ-XY
COPIER > ADJUST > ADJ-XY
ADJ-X 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
bit
-
-
-
OPEN Detection Sensor
Buffer Pass Exit Sensor
Buffer Pass Inlet Sensor
Adj of text density at image density adj
To adjust text density according to the adjusted image density.
As the greater value is set, text gets darker.
When clearing the RAM data of the Reader Controller PCB
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
When clearing the RAM data of the Reader Controller PCB, enter the value of service label.
1 to 9
5
Adj start pstn in book mode: vert scan
To adjust the image reading start position (image leading edge position) in the vertical scanning
direction at copyboard reading.
When replacing the Reader Controller PCB/clearing RAM data, enter the value of service label.
Decrease the value when the non-image width is larger than the standard value.
Increase the value when out of original area is copied.
As the value is incremented by 1, the image position is moved to the trailing edge side by 0.1 mm.
When replacing the Reader Controller PCB/clearing RAM data
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
-50 to 50
mm
0
0.1
Name
-
-
-
PS403
PS402
PS401
640
8. Service Mode
Circuit code Remarks
-
-
-
L: OPEN
L: Paper
L: Paper