Honeywell CN70 Series Service Work Instructions page 6

TITLE
CN70 Service Work Instructions
2. On a CN70A push the webbing through the slot in the battery latch until the retaining pin is exposed. A small
straight tipped screwdriver may be useful here since the pin fits tight in the battery latch. Remove the retaining pin
and slide the webbing out of the slot in the battery latch. For a CN70E unclip the lower end of the strap from the
bottom housing.
Push retaining pin
out of battery latch
CN70A
Installation is reverse order of removal. When re-installing the pin in a CN70A be sure to give the handstrap webbing
a good pull to seat the pin back into the battery latch.
Model
CN70A,CN70E
CN70A
DOCUMENT NO.
SWICN70-000 Page 6 of 45
CN70E
PAGE