Table of Contents
Advertisement
TITLE
CN70 Service Work Instructions
Installation
1. Position the scan bracket assembly over the main logic board and attach the scanner flex and camera flex cables..
2. Connect the 802.11 antenna coax to J4 on the main logic board.
3. Using a T7 torx driver install 4 screws and secure the scan bracket assembly to the core assembly with 2.5+/-0.2
in-lbs of torque.
4. Connect the scan switch/speaker cable to the main logic board. Make sure the cable is routed through the retention
feature in the bracket as shown below.
5. Re-install the bottom housing assembly.
Harness routed through
retention in bracket
Model
DOCUMENT NO.
CN70A,CN70E
SWICN70-000
PAGE
Page 19 of 45
Advertisement
Table of Contents
