Site Considerations - Grizzly G0824 Owner's Manual

Weight Load Weight Load
Refer to the Machine Data Sheet for the weight Refer to the Machine Data Sheet for the weight
of your machine. Make sure that the surface upon of your machine. Make sure that the surface upon
which the machine is placed will bear the weight which the machine is placed will bear the weight
of the machine, additional equipment that may be of the machine, additional equipment that may be
installed on the machine, and the heaviest work- installed on the machine, and the heaviest work-
piece that will be used. Additionally, consider the piece that will be used. Additionally, consider the
weight of the operator and any dynamic loading weight of the operator and any dynamic loading
that may occur when operating the machine. that may occur when operating the machine.
Space Allocation Space Allocation
Consider the largest size of workpiece that will Consider the largest size of workpiece that will
be processed through this machine and provide be processed through this machine and provide
enough space around the machine for adequate enough space around the machine for adequate
operator material handling or the installation of operator material handling or the installation of
auxiliary equipment. With permanent installations, auxiliary equipment. With permanent installations,
leave enough space around the machine to open leave enough space around the machine to open
or remove doors/covers as required by the main- or remove doors/covers as required by the main-
tenance and service described in this manual. tenance and service described in this manual.
See below for required space allocation. See below for required space allocation.
Children or untrained people Children or untrained people
may be seriously injured by may be seriously injured by
this machine. Only install in an this machine. Only install in an
access restricted location. access restricted location.
Keep
Workpiece
Loading Area
Unobstructed
Model G0824 (Mfd. Since 12/16)

Site Considerations

Wall
Electrical Box
Access Cover
Figure 13. Minimum working clearances.
Physical Environment Physical Environment
The physical environment where the machine is The physical environment where the machine is
operated is important for safe operation and lon- operated is important for safe operation and lon-
gevity of machine components. For best results, gevity of machine components. For best results,
operate this machine in a dry environment that is operate this machine in a dry environment that is
free from excessive moisture, hazardous chemi- free from excessive moisture, hazardous chemi-
cals, airborne abrasives, or extreme conditions. cals, airborne abrasives, or extreme conditions.
Extreme conditions for this type of machinery are Extreme conditions for this type of machinery are
generally those where the ambient temperature generally those where the ambient temperature
range exceeds 41°–104°F; the relative humidity range exceeds 41°–104°F; the relative humidity
range exceeds 20%–95% (non-condensing); or range exceeds 20%–95% (non-condensing); or
the environment is subject to vibration, shocks, the environment is subject to vibration, shocks,
or bumps. or bumps.
Electrical Installation Electrical Installation
Place this machine near an existing power source. Place this machine near an existing power source.
Make sure all power cords are protected from Make sure all power cords are protected from
traffic, material handling, moisture, chemicals, or traffic, material handling, moisture, chemicals, or
other hazards. Make sure to leave enough space other hazards. Make sure to leave enough space
around machine to disconnect power supply or around machine to disconnect power supply or
apply a lockout/tagout device, if required. apply a lockout/tagout device, if required.
Lighting Lighting
Lighting around the machine must be adequate Lighting around the machine must be adequate
enough that operations can be performed safely. enough that operations can be performed safely.
Shadows, glare, or strobe effects that may distract Shadows, glare, or strobe effects that may distract
or impede the operator must be eliminated. or impede the operator must be eliminated.
96"
Minimum
Lathe
30"
32"
24"
Minimum
-19-