Advertisement
6.
Measure machine base footprint size.
7.
Slide corner brackets over ends of side rails
(see Figure 9). Position corner brackets so
inside opening is
width and length of machine base footprint.
Note: Model T28923 only, make sure 21"
bars and 26" bars of equal length are installed
parallel to each other.
Inside
Opening
Figure 9. Properly assembled mobile base with
inside opening slightly larger than machine base
to ensure easy fit.
8.
Secure each end of corner brackets with (2)
M8-1.25 x 16 hex bolts (see Figure 10).
Bolts
Figure 10. Securing corner bracket to rail with
BOTH hex bolts.
BOTH hex bolts must be secured against
side rail in each end of corner brackets. DO
NOT load machine onto mobile base until all
bolts have been firmly tightened. Improper
tightening or using one bolt can result in
collapse or tipping when moving machine,
which could result in crushing injury or
property damage. DO NOT overtighten bolts.
Overtightening can strip threads.
-4-
⁄
"–
⁄
" larger than both
1
1
4
2
Hex
Side
Rail
9.
With the help of an assistant, or proper lifting
equipment, lift and position machine inside
mobile base (see Figure 11).
Figure 11. Example of machine properly placed
inside mobile base.
10. Verify machine is properly seated on mobile-
base corner pads, it is free of wobbles, and
there is no deflection in mobile base.
— Deflection: If any deflection exists, verify
all fasteners are securely tightened and
mobile base is properly assembled. If
this does not solve the problem, verify
machine does not exceed the rated weight
limit listed in Specifications on Page 1.
— Wobbles: Wobbles can easily be elimi-
nated by placing an appropriately sized
shim between machine and mobile base
where needed.
T28000 T28922 T28923 (Mfd. Since 11/18)
Advertisement
