Startup; Visual Checks; Initialize Module - Honeywell MT13-520 Manual

6.1 VISUAL CHECKS

• Check Module power and signal cables to ensure that they are present and tight.
• Check ground strap and/or leads on rear of chassis for good connection.
• Ensure that all boards and power supply are fully inserted into the connectors and that
board retainers are secured.

6.2 INITIALIZE MODULE

• Set power switch to on. Check all LEDs in accordance with Test Procedures,
subsection 3.2.
• Press button. Check LEDs again as above.
RESET
Multinode Module Service 6-1
6

STARTUP

Section 6
9/95