Honeywell MT13-520 Manual page 14

Power must be removed from the module whenever you are removing or installing any board,
including an I/O paddleboard. Be sure that an I/O paddleboard is installed in the correct slot;
some boards have only one slot that they can be installed in without causing damage. I/O
paddleboards plugged into the wrong slot can cause traces on the backplane to burn open.
Note that a given node may occupy slots 1-2-3, 4-5-6, 7-8, or 9-10 to match slots a-b-c, or
only a-b.
Table 2-1 — Node Configurations for Multinode Modules (Continued)
Computer Gateway (CG)
Slot Front
c
b CLI
a K2LCN-2
Redundant NIM
Slot Front
b EPNI
a K2LCN-3
Notes: (1) A TP485 I/O card is located in Slot 1 and 9 of the modules in the Micro TDC 3000.
(2) The TP485 in Slot 9 provides the interface to the twisted pair, short distance
(≤10 meters) TPLCN.
Multinode Module Service
CAUTION
Rear Slot
c
CLI I/O b
a
Rear Slot
NIM MODEM b
(1, 2) a
2-4
PLC Gateway (PLCG)
Front
PLCI PLCI I/O
K2LCN-2
Network Gateway (NG)
Front
NGI NGIO
K2LCN-2
2.2.1
Rear
Rear
9/95