Table of Contents
Advertisement
70
Chapter 5 Capturing Images and Videos
To Quick-Record, Bypassing Menus
Press and hold
A flashing red dot appears. As long as this dot is flashing, the system is recording. If using
a DVD, recording starts only after the DVD drive light stops flashing. If you start recording
to a new DVD that has not been initialized manually, the system automatically initializes it
before recording. See "Initializing DVDs" on page 68.
To Pause Recording
1. Press
- or -
Press
Recording stops temporarily. The pause symbol appears:
2. When ready to resume, press
- or -
Press
The red dot flashes again. Recording resumes.
Note
To Stop Recording
Press and hold
-or-
Press
Note
.
quickly.
. Select Video Record > Pause.
. Select Video Record > Resume Recording.
Each time you pause and then resume video recording, the system continues
saving to the same MPEG file. If you are recording to a DVD, the first pause or
stop takes about a minute to process. The total number of times you can pause
and stop varies with DVD type. See
.
. Select Video Record > Stop.
Each time you stop recording, the system creates a separate MPEG file. If you are
recording to a DVD, the first pause or stop takes about a minute to process. The
total number of times you can pause and stop varies with DVD type. See
Types Accepted"
on page 68.
GE Inspection Technologies XLG3 VideoProbe System
again.
"DVD Types Accepted"
on page 68.
"DVD
Advertisement
Table of Contents
Troubleshooting
