Communicating To A Pc Through A Router Or Network - GE Everest XLG3 VideoProbe Operating Manual

34 Chapter 3 Setting Up and Putting Away the System

Communicating to a PC Through a Router or Network

PC and network connectivity — wired or wireless — are part of the optional network
package. (See
If the XLG3 system is connected to a PC or network, you can send images and videos to
other computers for review, further manipulation, or remeasuring. You can also send
images from other computers to the XLG3 system.
To Connect the XLG3 System to a PC Through a Router or Network Via an Ethernet
Cable
1. At the base unit, plug an Ethernet cable into the Ethernet connector
2. Plug Ethernet cable into a network port.
The XLG3 Ethernet connector's LEDs light up to indicate that the connection is
established.
3. Connecting the XLG3 to a PC:
If a local area network (LAN) port is not available, connect the XLG3 to the PC by
placing an Ethernet router between them. The router will generate an IP address as
described on page 45.
4. No additional software is needed to simply share files with a PC or network via a direct
Ethernet connection, using Microsoft™ Internet Explorer.
5. PC Based Re-Measurement iView - This application lets you manage and measure
images that were captured by the XLG3 system. It also lets you create reports from
those images. To obtain iV
No software is needed to simply share files with a PC or network via a direct Ethernet
connection.
"About the Network Package"
PC, contact GE Inspection Technologies.
IEW
GE Inspection Technologies XLG3 VideoProbe System
on page 5.)
.