Cisco Catalyst 9600 Series Installation Note page 9

Warning
Class 1 LED product. Statement 1027
Warning
Blank faceplates and cover panels serve three important functions: they prevent exposure to hazardous voltages
and currents inside the chassis; they contain electromagnetic interference (EMI) that might disrupt other
equipment; and they direct the flow of cooling air through the chassis. Do not operate the system unless all
cards, faceplates, front covers, and rear covers are in place. Statement 1029
Warning
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Warning Hazardous voltage or energy is present on the backplane when the system is operating. Use caution when
servicing. Statement 1034
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
1040
Warning To prevent the system from overheating, do not operate it in an area that exceeds the maximum recommended
ambient temperature of 104°F (40°C). Statement 1047
Warning
Stability hazard. The rack stabilizing mechanism must be in place, or the rack must be bolted to the floor
before you slide the unit out for servicing. Failure to stabilize the rack can cause the rack to tip over. Statement
1048
Warning
The chassis should be mounted on a rack that is permanently affixed to the building. Statement 1049
Warning
Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or
view directly with optical instruments. Statement 1051
Warning Class 1M laser radiation when open. Do not view directly with optical instruments. Statement 1053
Cisco Catalyst 9600 Series Line Card Installation Note
Safety Warnings
9