Servicing Your Tiller (Continued); Engine Oil Change - Honda F300 Owner's Manual

4MV488000.book 33 ページ ２０１６年３月２日 水曜日 午後１２時３６分

ENGINE OIL CHANGE

Drain the oil while the engine is warm to assure rapid and complete
draining.
1. Pull up the handlebar while holding it to contact the front end of the
tiller to the ground.
2. Place a suitable container below the engine to catch the used oil,
and then remove the engine oil filler cap, drain plug, and sealing
washer.
TORQUE: 17.5 N∙m
3. Allow the used oil to drain completely, and then reinstall the drain
plug and a new sealing washer. Tighten the plug securely.
Improper disposal of engine oil can be harmful to the environment.
If you change the oil on your own, please dispose of the used oil properly.
Put it in a sealed container and take it to a recycling center. Do not
throw it in the trash, pour it on the ground, or pour it down a drain.
4. With the tiller in a level position (see page 29), fill with the
recommended oil (see page 34) to the outer edge of the oil filler
hole.
Maximum oil capacity: 0.36 L
SEALING WASHER
(Replace)
DRAIN PLUG
SERVICING YOUR TILLER
ENGINE OIL FILLER CAP
UPPER LIMIT
33