Makita BHR261 Technical Information page 4

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -1. Bit holder section for BHR261/ Holder section for Drill chuck of BHR261T
DISASSEMBLING for BHR261
Fig. 4
1R003
Ring 21
Chuck cover
Remove Cap 35 with slotted screwdriver
and then remove Ring spring 19 with
1R003.
ASSEMBLING for BHR261
Take the disassembling step in reverse.
Note: Be sure to place the flat portion of Ring spring 19 on Steel ball 7.0. (Fig. 4)
DISASSEMBLING for BHR261T
Fig. 5
Tool holder set
Tool holder guide
Separate Tool holder set from
Tool holder guide complete.
Stopper
Guide washer
Conical compression
spring 21-29
Flat washer 21
Tool holder
Stopper, Guide washer, Conical
compression spring 21-29, Flat
washer 21 can be removed.
Chuck cover
Cap 35
Ring spring 19
Ring 21
Flat portion
Remove Chuck cover.
Then remove Steel ball 7.0
while pressing down Ring 21.
Cap 35
Ring spring 19
Remove Cap 35 and then remove
Ring spring 19 with 1R003.
Ring spring 21
Flat washer 24
Leaf spring
Steel ball 5
Remove Ring spring 21 with
1R004 From Tool holder
guide side.
Flat washer 24, Leaf spring
and Steel ball 5 can be
removed.
Steel ball 7.0
Bit holder section can be
disassembled as illustrated above.
Chuck cover
1R003
Steel ball 7.0
Remove Chuck cover and then
remove Steel ball 7.0 while
pressing down Stopper.
Tool holder
Torsion spring 31
Change ring
Change cover
Remove Tool holder
together with Change
ring from Change cover.
And separate Change
ring from Tool holder.
P 4/ 21
Ring 21
Guide washer
Conical compression
spring 21-29
Stopper
Torsion spring 31
Steel ball 6 (2 pcs.)
After removing Torsion
spring 31, Steel ball 6
can be separated from
Tool holder.