Honeywell Galaxy TouchCenter Plus User Manual page 11

To cancel an alarm, fault or tamper:
ICON
1. On the screen, press the
Home
2. Enter a valid PIN (Personal Identification Number)
code, and then press
The buzzer will be silenced and the cause of the
activation will be displayed.
Note: After an alarm, fault or tamper has occurred the system must be reset in order to be used again.
To reset the system after an alarm, fault or tamper:
ICON
1. Clear the cause of the alarm, fault or tamper. (A call to
your installer may be required)
2. On the Home screen, press the
3. Enter a valid (Personal Identification Number)
PIN
code, and then press
4. On the keypad, view the alarm, fault or tamper
conditions.
5. Press the Reset icon.
If the condition has cleared and your PIN has sufficient
authority then the alarm, fault or tamper is reset.
Security (cont'd)
ACTION
icon.
Security
.
ent
ACTION
Security icon.
ent .
11
NOTES
Any alarm, fault or tamper condition that has not been cleared is shown
each time a PIN is entered. When the condition is first activated, you
are alerted by the keypad buzzer.
NOTES