Table of Contents
Advertisement
Arbor/Chuck
Assembly
An arbor is included for the drill chuck that
comes with this machine. The following procedure
describes how to install the arbor in the chuck.
After the arbor is installed in the drill chuck, it
is very difficult to separate the assembly. If you
would like to use a different chuck in the future,
we recommend obtaining a new arbor.
IMPORTANT: DO NOT install the drill chuck
and arbor assembly into the spindle until AFTER
the test run.
To join drill chuck and arbor:
1.
Use acetone or lacquer thinner to clean drill
chuck and arbor mating surfaces, especially
the bore.
2.
Retract chuck jaws completely into chuck.
3.
Insert small end of arbor into chuck.
4.
Hold assembly by the arbor and tap chuck
onto a block of wood with medium force, as
illustrated below.
Figure 10. Arbor/chuck assembly.
5.
Attempt to separate drill chuck and arbor by
hand —if they separate, repeat Steps 3–4.
Model G0779 (Mfd. Since 09/14)
Initial Lubrication
GEARBOX MUST
BE FILLED WITH OIL!
OIL MAY NOT BE
SHIPPED WITH MACHINE!
Refer to Lubrication Section
for Correct Oil Type.
To prevent spillage, this machine was shipped
from the factory without any oil in it. The head-
stock oil reservoir must be properly filled with oil
before the drill press can be operated for the first
time. Refer to the Lubrication section, beginning
on Page 31, for details on how to check and add
oil.
Damage caused by running the drill press
without oil in the reservoir will not be cov-
ered under warranty.
-17-
Advertisement
Table of Contents
