Configuration Restore With Force Option - HP Aruba JL253A Management And Configuration Manual

Time Taken for Each Phase :
Calculating diff
Adding commands
Removing commands
switch(config)# show config files
Configuration files:
id | act pri sec | name
---+-------------+---------
1 | * *
2 |
3 |
4 |
5 |

Configuration restore with force option

Prerequisites
Back up the configuration using traditional copy config or cfg-backup commands.
Procedure
1. Execute the show config files command. By default, the config file provides all the associations.
switch(config)# show config files
Configuration files:
id | act pri sec | name
---+-------------+-------
1 | *
2 |
3 |
4 |
5 |
2. Use cfg-restore flash file1 force command to see the configuration of file1.
switch(config)# cfg-restore flash file1 force
As the file1 configuration requires a reboot, a system reboot occurs. When the switch comes up, file1 is the
new active configuration.
switch(config)# sh config files
Configuration files:
id | act pri sec | name
---+-------------+---------
1 |
2 | *
3 |
4 |
5 |
568
: 1 Seconds
: 0 Seconds
: 0 Seconds
* | config
|
|
|
|
* * | config
| file1
| file2
|
|
* * | config
| file1
| file2
|
|
NOTE: During a configuration restore with reboot, the association changes. To make the
configuration as a default configuration for subsequent system reboots, use startup-default
[<primary|secondary>] config FILENAME command.
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08