Commands Used In Switch Configuration Restore Without Reboot; Configuration Backup - HP Aruba JL253A Management And Configuration Manual

For arubaos-switch 16.08

Table of Contents

switch(config)# show cfg-restore status

Config File Name

Recovery Mode

Failure Reason

Number of Add Commands

Number of Remove Commands : 0

Time Taken for Each Phase :

Calculating diff

Adding commands

Removing commands

Commands used in switch configuration restore without

Backs up the selected configuration to the flash file.

show config files details

Shows a detailed list of configuration files available in the flash.

Restores the given configuration as the running configuration without reboot.

show cfg-restore status

Shows the status of latest restore performed.

show cfg-restore latest-diff

Views the list of configuration changes that are removed, modified, or added to the running configuration.

Shows the SHA ID of a startup or running configuration.

The configuration backup creates a backup of the running or startup configuration of ArubaOS-Switch on-demand

to the flash storage on the switch. The maximum number of backup files supported has increased from three to

NOTE: When you downgrade configuration backup files from five to three, and if the current number

of files is either a four or five, an error message Configuration file <name> stored in

config index 5 is not supported in lower image versions is displayed.

Chapter 15 Configuration backup and restore without reboot

: cfg_rollback

: Tue Nov 28 20:50:00 2017

NOTE: If the configuration involves any sensitive information, backup and restore the

configuration by enabling the include-credentials command.

Troubleshooting