Event Scenario Matrix; Enabling And Disabling Traps; Snmp Trap Captures Examples - HP Aruba JL253A Management And Configuration Manual

• Authentication failure notifications
• Enterprise change notifications
• Intrusion alarm notifications

Event scenario matrix

Different event scenarios for which traps are generated:
Event Id Severity
68 Info
67 Info
405 Info
406 Info
552 Warning
552 Warning

Enabling and disabling traps

Action
Disable both the log and
trap
Enable log only
Enable both the log and
trap (Default)
Enable trap only
NOTE: If the event is configured to disable a trap, then the trap will not be sent for that particular
event. In all other scenarios, a trap is generated for the listed events.

SNMP trap captures examples

Inserting a slot module
Event Id: 68
208
Action
Slot Insertion
Slot Removal
Transceiver Insertion I 06/20/16 09:18:56 00405 ports: AM1: port A23 xcvr hot-
Transceiver Removal I 06/20/16 09:19:04 00406 ports: AM1: port A23 xcvr hot-
Stacking module
Insertion
Stacking module
Removal
Command
setMib eventType.<event_Id> -i 1 – to disable both log & Trap
setMib eventType.<event_Id> -i 2 – to allow only log
setMib eventType.<event_Id> -i 4 – to allow both log & Trap
setMib eventType.<event_Id> -i 3 – to allow only trap
Aruba 2930F / 2930M Management and Configuration Guide
Message
I 06/20/16 09:18:43 00068 chassis: AM1: Slot C Inserted
I 06/20/16 09:18:50 00067 chassis: AM1: Slot C Removed
swap insert
swap remove
W 04/20/16 09:20:43 00552 chassis: ST1-CMDR: Stacking
Module insertion detected: Reboot required
W 06/20/16 09:19:43 00552 chassis: ST1-CMDR: Stacking
Module removal detected: Reboot required
for ArubaOS-Switch 16.08