Priority SNTP Server Address
-------- ------------------------------ ----------------
1
2001:db8::215:60ff:fe79:8980
2
10.255.5.24
3
fe80::123%vlan10
Syntax:
show management
This command can help you to easily examine and compare the IP addressing on the switch. It lists the IP
addresses for all time servers configured on the switch, plus the IP addresses and default gateway for all VLANs
configured on the switch.
Display showing IP addressing for all configured time servers and VLANs
switch(config)# show management
Status and Counters - Management Address Information
Time Server Address : fe80::215:60ff:fe7a:adc0%vlan10
Priority
--------- ------------------------------ ----------------
1
2
3
Default Gateway
VLAN Name
------------ --------------- + ---------------
DEFAULT_VLAN 001279-88a100
VLAN10
Configuring (enabling or disabling) the SNTP mode
Enabling the SNTP mode means to configure it for either broadcast or unicast mode. Remember that to run SNTP
as the switch's time synchronization protocol, you must also select SNTP as the time synchronization method by
using the CLI timesync command.
Syntax:
timesync sntp
Selects SNTP as the time protocol.
sntp {<broadcast | unicast>}
Enables the SNTP mode.
Syntax:
sntp server <ip-addr>
Required only for unicast mode.
36
SNTP Server Address
2001:db8::215:60ff:fe79:8980
10.255.5.24
fe80::123%vlan10
:10.0.9.80
MAC Address
001279-88a100
Protocol Version
7
3
3
Protocol Version
7
3
3
| IP address
| Disabled
| 10.0.10.17
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08