Collecting Processor Data With The Task Monitor (Cli); Task-Monitor Cpu - HP Aruba JL253A Management And Configuration Manual

System Name
System Contact
System Location
MAC Age Time (sec) : 300
Time Zone
Daylight Time Rule : None
Software revision
ROM Version
Up Time
CPU Util (%)
IP Mgmt - Pkts Rx

Collecting processor data with the task monitor (CLI)

The task monitor feature allows you to enable or disable the collection of processor utilization data. The task-
monitor cpu command is equivalent to the existing debug mode command taskusage -d.
When the task-monitor command is enabled, the show cpu command summarizes the processor usage by
protocol and system functions.
Syntax:
[no] task-monitor cpu
Allows the collection of processor utilization data.
Only manager logins can execute this command.
The settings are not persistent, that is, there are no changes to the configuration.
(Default: Disabled)
The task-monitor cpu command and show cpu output
switch(config)# task-monitor cpu
switch(config)# show cpu
2 percent busy, from 2865 sec ago
1 sec ave: 9 percent busy
5 sec ave: 9 percent busy
1 min ave: 1 percent busy
% CPU | Description
-------+-----------------
99 | Idle

task-monitor cpu

Syntax
[no] task-monitor cpu
Description
378
: Switch
:
:
: 0
: T.13.XX
: XX.12.12
: 51 secs
: 3
:0
Pkts Tx :0
Base MAC Addr : 001635-b57cc0
Serial Number : LP621KI005
Memory - Total : 152,455,616
Free : 100,527,264
Packet - Total : 6750
Buffers Free : 5086
Lowest : 5086
Missed : 0
Aruba 2930F / 2930M Management and Configuration Guide
for ArubaOS-Switch 16.08