Table of Contents
Advertisement
S4 Beam Sensor & brackets
How to set up a Beam sensor STATE
The Beam Sensor is factory set to operate at STATE 0. To configure the beam sensor to operate in a
different STATE you will need to change the device setup of the 'beam receiver'.
The STATE setting of a 'beam receiver' is usually done during commissioning of the system using the
commissioning tool, however it is possible to use the panel menus to change the sensor operating
STATE. Enter the required STATE number for both Enable (Day) and Disable (Night) time periods.
You will need to know the 'beam receiver' device address and loop number on which it is installed.
Procedure for Vigilon panel (Access level 3)
[Set Up]
[UserCode]
Enter the
Params
[Loop]
1-207
Params
[State]
1-8
enable
Params
[State]
0-15
disable
Params
[E]
[C] [Q]
0-15
The entered
STATES
You can check the STATE setting of a 'beam receiver'
by viewing the device 'Status' of the 'beam receiver'.
Procedure for Nano panel (Access level 3)
Menu
Settings
4188-968 issue 4_Part 2_07-12_S4 mains interface
<etc>
<etc>
device address
of the '
Enter the
loop number
of the device
Enter the
Enable STATE
The 'Enable' and 'Disable' STATES must be the same
if the beam sensor is to continuously operate in the
same state throughout each day.
Enter the
Disable STATE
are setup at the 'beam receiver'.
Select
Loop
Typical example of Beam Receiver form
Device:[
24] Settings
Label:[Device Label
Type: Beam Receiver
Assigned to Zone:[ 1]
Sensitivity States
Gain:[63]
Save
Enter the Day and Night sensitivity STATES
To scroll the range
[Device]
[Set Up]
beam receiver'
number
number
>
Select
16:48 Fri 26/04/08
Find:[OFF]
]
Sect:[ 2]
Night:[ 0] Day:[ 0]
Quit
To move to next setting
Commissioning information
Enter the 'beam receiver'
device address
Devices
Save
11
Advertisement
Table of Contents
