Makita EB7650TH Technical Information page 8

(5) When fitting Engine cover complete (d), follow the instructions described in Fig. 11. Make sure that Carburetor gasket is on the inner
side of the rib inside Engine cover complete and that Plug cover is not pinched.
Align the fixing screw boss positions and then fit the cover and secure it in place with the four screws. (Fig. 3)
Fig. 11
Choke lever
Carry out disassembly and assembly
with Choke lever raised or the lever
will catch on the engine cover.
(6) Secure Band completes L and R with the fixing parts by reversing the disassembly procedure shown in Fig. 1 while taking care not to mix
them up.
Twist the bands; Band complete R by 90 degrees clockwise and Band complete L by 90 degrees counterclockwise viewed from the top,
and then attach them. (Fig. 12)
Fig. 12
Right
Cylinder block
assembly
Insert along the guides
Left
Twist 90 degrees
Makita Corporation
Oil guard:
Attach before fitting Engine
cover complete.
(d)
Recoil starter
Four 5x20
Tapping screws
P 8/ 35
Three M5x20
Pan head screws