Makita EB7650TH Technical Information page 5

(2) Loosen three M5x20 Pan head screws and then remove Recoil starter (a). (Fig. 2)
(3) Loosen four 5x20 Tapping screws and then remove Engine cover (b). (Fig. 3)
Fig. 2
(4) Remove six M5x16 Hex socket head bolts from the bottom and front of Frame (c). (Fig. 4)
Fig. 4
Guard
Loosen this screw
only when removing
Guard.
(c)
(5) Lift up Fuel tank and disconnect the earth wire of Ignition coil from the brass M5-10 Hex nut beneath Fuel tank. (Left photo of Fig. 5)
(6) Disconnect Ignition coil at the bullet terminals (d) (Center photo of Fig. 5), then disconnect Control cable (e) from Carburetor (f)
(Right photo of Fig. 5), and then remove the integrated Control cable (e) and Lead unit from Front volute case (h). In the case of
EB7650WH, remove Control cable (e) from Clip (g). (Center photo of Fig. 5)
Fig. 5
Disconnect the wire from the
earth terminal.
M5-10 Hex nut
(7) Remove the engine, Volute case and Fuel tank together and then replace Frame (c).
Fig. 3
(a)
(c)
Disconnect (e) from (d) and (g).
(d)
For Model EB7650WH,
remove (e) from (g).
Makita Corporation
(b)
Disconnect (e) from (f).
(e)
(g)
2. Return Throttle
lever to its original
position and remove
the wire end.
P 5/ 35
(f)
1. Pull Throttle lever
and then hold it in
place with a finger.