Cisco D9800 Getting Started page 11

Getting Started
Task
Assigning a Channel to a Program Entry
Configuring the ASI or MPEGoIP Output General
Settings
Mode
Configuring the SDI Outputs
Configuring the ASI or MPEGoIP Output General
Settings
Streams
Typical Digital Program Mapping Setup
and Configuring the ASI or MPEGoIP Output
and Configuring MPEG over IP or IP Data
Cisco D9800 Network Transport Receiver Version 3.11 Installation and Configuration Guide
Description
Assign a program channel to a program entry.
Set the following ASI output parameters:
• Output Mode - We recommend to set it to MAP
Service Channels Only. Select Yes if requested
to Resync All.
• Descramble Mode
• Insert Null Packet - Set to Yes.
Choose the SDI1 and SDI2 outputs. The SDI outputs
are only available on units with the SDI option
installed (D9800-3G-SDI).
Configure the MPEG over IP output and stream
settings. The MPEGOIP outputs are only available
on units with the MPEGOIP input/output option
installed (D9800-SS-MPEGOIP).
For multi-stream units (D9800-MS-MPEGOIP),
configure the IP data output and stream settings.
Set the DPM mode.
Quick Setup
11