Makita EM4350UH Technical Information page 6

R
epair
[4] DISASSEMBLY/ASSEMBLY
[4]-3. Shaft pipe complete (cont.)
ASSEMBLING
For 4351UH:
(1A) Insert Buffer rubber into Pipe housing so as to align the two grooves
with the two ribs (Fig. 16) Set the four Buffer rubbers in place of
Pipe housing. (Fig. 17)
(2A) Insert two projections of Clutch case into Buffer rubbers.
Insert two projections of Housing holder into the other Buffer rubbers,
then tighten M5x18 Hex socket head bolt while holding Housing
holder by hand. (Fig. 17)
Note: Make sure that Corrugate tube is put in the groove of Pipe housing.
(Fig. 18)
(3A) Assemble by reversing the disassembly procedure.
For 4350UH and 4350LH:
Assemble by reversing the disassembly procedure.
Fig. 17
Projections of Clutch case
Fig. 18
Groove of Pipe housing
Pipe housing
Buffer rubber (4 pcs.)
Corrugate tube
Fig. 16
Ribs of Pipe housing
Grooves of
Buffer rubber
P / 2
Housing holder