Makita EM4350UH Technical Information page 5

R
epair
[4] DISASSEMBLY/ASSEMBLY
[4]-3. Shaft pipe complete (cont.)
DISASSEMBLING
For 4351UH:
(5A) Loosen M5x18 Hex socket head bolt and remove Shaft pipe complete from Pipe housing. (Fig. 11)
(6A) Pull out Shaft from Shaft pipe complete.
For 4350UH:
(5B) Remove two M6x25 Hex socket head bolts and Pipe clamp, then separate Bike handle section from Shaft pipe
complete. (Fig. 12)
(6B) Remove the following parts from Shaft pipe complete.
• Wire clamp (2 pcs.) • Hanger set • Shaft (Fig. 13)
For 4350LH:
(5C) Remove four M5x30 Hex socket head screws, then remove Handle clamp 28 and then remove Loop handle 28.
(Fig. 14)
(6C) Loosen two M5x14 Hex socket head bolts, then separate Lever case set from Pipe shaft complete. (Fig. 15)
(7C) Remove the following parts from Pipe shaft complete.
• Hanger set • Spacer • Shaft
Fig. 11
Pipe housing
M5x18 Hex socket head bolt
Fig. 13
Shaft
Wire clamp (2 pcs.)
Shaft pipe
complete
Hanger set
Fig. 12
Shaft pipe
Fig. 14
M5x30 Hex socket
head screw (4 pcs.)
Handle clamp 28
Pipe clamp
Fig. 15
Loop handle 28
Shaft pipe
complete
P / 2
Bike handle section
Shaft pipe complete
M6x25 Hex
socket head bolt
Control lever assembly
M5x14 Hex socket
head bolt (2 pcs.)