Makita EM4350UH Technical Information page 4

R
epair
[4] DISASSEMBLY/ASSEMBLY
[4]-2. Engine and Shaft (cont.)
ASSEMBLING
Assemble by reversing the disassembly procedure.
(1) Put Cable bracket between Flat washer 6 and middle Nut, and tighten them by turning lower nut, upper nut and
the middle nut. (Fig. 7)
(2) Put Stopper on Inner cable end into Swivel, then adjust the above nuts so that 3mm to 4mm of play is left inside of
Swivel under condition that Throttle lever is not pulled. (Fig. 7)
Note: Adjust the tension of Inner cable to prevent the stopper from being removed . (Fig. 7)
Fig. 7
Stopper on Inner cable end
Cable bracket of Insulator
complete
[4]-3. Shaft pipe complete
DISASSEMBLING
(1) Loosen two M6x30 Hex. socket head bolt (2pcs.) and remove Protector with Protector extension attached. (Fig. 8)
(2) Enlarge the space between the side wall of Protector cover and M5x14 Hex socket head bolt, and remove Protector cover
from Shaft pipe complete. (Fig. 9)
(3) Remove two M5x14 Hex socket head bolts then remove Protector clamp.
(4) Loosen M6x30 Hex socket head bolt then remove Gear case assembly. (Fig. 10)
Fig. 8
M6x30 Hex. socket
head bolt (2 pcs.)
Protector
Protector extension
Fig. 10
M6x30 Hex
socket head bolt
Protector clamp
Nut (upper)
Nut (middle)
Flat washer 6
Nut (lower)
Fig. 9
M5x14 Hex socket head bolt (2 pcs.)
The side wall of
Protector cover
Gear case assembly
M5x14 Hex socket
head bolt (2 pcs.)
Play: 3mm to 4mm
Swivel
Shaft pipe
complete
Gear case
assembly
P / 2