Makita EM4350UH Technical Information page 3

R
epair
[4] DISASSEMBLY/ASSEMBLY
[4]-2. Engine and Shaft
(1) Press down the tab of Cleaner plate assembly gently and separate Cleaner cover assembly from Cleaner plate assembly
by loosening M5x20 Hex socket head bolt. (Fig. 1)
(2) Loosen 5x16 Tapping screw and loosen Clamp that holds Bullet terminals near Cleaner plate assembly. (Fig. 2)
(3) Disconnect Bullet terminals of Earth wire and Primary wire of Ignition coil from the wires of Stop switch. (Fig. 2)
(4) Remove Control cable from Swivel of Carburetor; loosen the three nuts on Control cable to release the tension
between Swivel and Cable bracket of Insulator, then remove the stopper on Inner cable end from Swivel. (Fig. 3)
(5) For EM4351UH: Remove M5x8 Hex socket head bolt and M6x30 Hex socket head bolt in the holes of Pipe housing.
(Fig. 4)
For EM4350UH and EM4350LH: Remove M5x8 Hex socket head bolt and M6x30 Hex socket head bolt from
(6) Grab Shaft pipe complete by hand, then pull it off from Clutch case.
If Shaft sticks in Clutch case, use water pump pliers or the like to pull it off.
Note: Be sure to wrap Shaft with a rag or the like to protect it from water pump pliers. (Fig. 6)
Fig. 1
M5x20 Hex socket
head bolt
Cleaner plate assembly
Fig. 3
Stopper on Inner cable end
Cable bracket of Insulator
Nut on Control cable end
(3 pcs.)
Fig. 5
Threaded holes
of Clutch case
M5x8 Hex socket M6x20 Hex
head bolt socket head bolt
the threaded holes of Clutch case. (Fig. 5)
Fig. 2
Swivel of Carburetor
Inner cable
Clamp
Control cable
5x16
Tab of Tapping
screw
Swivel of Carburetor
Fig. 6
Shaft pipe complete
Cleaner plate assembly
Fig. 4
Holes of
Pipe housing
M5x8
Hex socket
head bolt
M6x20
Hex socket
head bolt
Rag Shaft
P / 2
Bullet terminals
Water pump
pliers