Adding User Codes - Honeywell 8712009 Installation & Operation Manual

LOCKING AND UNLOCKING
TO UNLOCK THE LOCK
Using Keypad: Enter a valid User Code (default code is 1234) and press
1 beep and lights green.
TO LOCK THE LOCK
Using Keypad: Press
CHANGING PROGRAMMING CODE
CHANGE CURRENT OR PRESET PROGRAMING CODE
Factory default Programming Code
your lock. All programming functions require this code. Follow the below sequence to
change the Programming Code
PC
Hear 1 beep and Light Indicator illuminates green.
Record New and Changed Codes on Programming Record located on Page 17.

ADDING USER CODES

TO ADD A NEW USER CODE (you can add up to 50 new user codes)
The User Code
to a User ID
ID
Code . (User ID
UC
For example: to add the User ID - 08 to User Code - 5678, enter the following:
PC
123456
Hear 1 beep and Light Indicator illuminates green.
NOTE: When a NEW USER CODE is set, the default factory code (1234) is deleted
for safety.
Record New and Changed Codes on Programming Record located on Page 17.
and then hear 2 beeps and lights red.
PC
4 new
must be a 4-8 digit combination. Each User Code
UC
(which is any number between 01-50) to identify an individual User
1-9 should be entered as 01-09 so they are 2 digits).
ID
1
ID
08
= 123456, this is the master password for
PC
to your custom 6 digit combination.
Re-enter
PC
UC
5678
PC
PC
is then linked
UC
Re-enter
UC
5678
and hear
Page 10