Installing Deadbolt Latch Set - Honeywell 8712009 Installation & Operation Manual

INSTALLING DEADBOLT LATCH SET

3. INSTALLING THE DEADBOLT LATCH SET (need phillips head screwdriver)
a. Insert Deadbolt Latch Set into door edge hole with the word
"UP" and the arrow on the extension plate facing UP. Cross
shaped spindle connector will be at the bottom of the Deadbolt
Latch Set (Figure 3a).
b. Make sure the face plate sits flush with the door. Do not force
the latch into the mortise flush. Chisel out excess material if
necessary for a flush fit.
c. Using two 3/4" (19mm). screws provided, screw the latch into the
door with a hand held screwdriver. DO NOT OVER TIGHTEN.
NOTE: Deadbolt Latch must be retracted when installing
4. IDENTIFYING YOUR DOOR HANDING
Stand outside the door.
a. If the hinges are on the left your door is Left Handed (Figure 4a).
b. If the hinges are on the right your door is Right Handed (Figure 4b).
OUT SWING DOOR
Left Handed Door
Hinges are on the left side
Figure 4a
NOTE: You are standing outside the door
Deadbolt Latch Extended
Right Handed Door
Hinges are on the right side
Deadbolt Latch Retracted
IN SWING DOOR
Left Handed Door
Hinges are on the left side
Figure 4b
Figure 3a
Right Handed Door
Hinges are on the right side
Page 4