Honeywell 8712009 Installation & Operation Manual page 10

INSTALLING INTERIOR ASSEMBLY (CONT.)
13. Installing Batteries
a. Insert 4 AA high quality Alkaline batteries into the Battery Compartment in the
direction noted +/- on the Compartment. The Lock will beep 2 times, the keypad
will illuminate blue, and the Honeywell button will flash green twice to signify that
it has received power (Figure 13a).
NOTE: Do not touch the Keypad until the blue light turns off.
Do not use rechargeable batteries or non-alkaline batteries.
b. Slide the Battery Cover down into the track on the Interior Assembly to cover
the batteries (Figure 13b).
14. Testing Lock
With the Door Open
a. Test the Lock using the Interior Knob. The bolt should move smoothly.
b. Test the lock using the Keypad. To lock press
to unlock.
INSTALLATION OVERVIEW
Light Indicator
Keypad
Override
Access Key
Exterior Assembly
Strike Plate
3/4" (19mm)
screws
Mounting Plate
Key
Interior
Knob
Figure 13a-b
Interior Assembly
and then press " 1234"
Interior Assembly
Optional
3/4" (19mm)
screw
7/8" (22mm) screws
Latch
Exterior Assembly
Rubber Gasket
Battery
Cover
Battery Cover
5/16" (8mm) screws
1" (25mm) Screw
Page 8