Adjusting Deadbolt Latch Set - Honeywell 8712009 Installation & Operation Manual

ADJUSTABLE DEADBOLT LATCH SET
NOTE: Deadbolt Latch Set is shipped with the backset set at 2-3/8" (60mm)
Measure the backset (backset is distance between edge of the door and the
center of Lock).
1. TO CONVERT FROM 2-3/8" (60mm) BACKSET TO 2-3/4" (70mm) BACKSET
a. Hold latch with numbers facing forward and thumb pressing on the bolt (Figure 1a).
b. Rotate the cylinder cover clockwise (Figure 1b).
c. Pull and twist the extension plate all the way out (Figure 1c).
d. Rotate the cylinder cover counter clockwise so that the marking aligns with
the 2-3/4" (70mm) position indicator (Figure 1d).
NOTE: Do not extend Cylindrical Cover past 2-3/4" (70mm)
Figure 1a
Cylindrical cover
2. TO CONVERT FROM 2-3/4" (70mm) BACKSET TO 2-3/8" (60mm) BACKSET
a. Hold latch with numbers facing forward and thumb pressing on the bolt (Figure 2a).
b. Rotate the cylinder cover clockwise (Figure 2b).
c. Push and twist the extension plate all the way in (Figure 2c).
d. Rotate the cylinder cover counter clockwise so that the marking aligns with
the 2-3/8" (60mm) position indicator (Figure 2d).
Figure 2a
Cylindrical cover
Figure 1b
2-3/8"
(60mm)
Extension plate
Figure 1d
Figure 2b
2-3/4"
(70mm)
Extension plate
Figure 2d
Figure 1c
2-3/4"
(70mm)
2-3/8"
(60mm)
Figure 2c
2-3/8"
(60mm)
Your latch is now set
2-3/4" (70mm) backset
Your latch is now set
2-3/8" (60mm) backset
Page 3