Adding User Codes - Honeywell 8732001 Installation & Operation Manual

Locking and Unlocking
TO UNLOCK THE LOCK
Using Keypad: Enter a valid User Code (default code is 1234) and press and hear
1 beep and lights green.
TO LOCK THE LOCK
Using Keypad: Press and then hear 2 beeps and lights red.
Changing Programming Code
CHANGE CURRENT OR PRESET PROGRAMING CODE
Factory default Programming Code = 123456, this is the master password for
your lock. All programming functions require this code. Follow the below sequence to
change the Programming Code to your custom 6 digit combination.
PC
Hear 1 beep and Light Indicator illuminates green.
Record New and Changed Codes on Programming Record located on Page 13.
Adding User Codes
TO ADD A NEW USER CODE (you can add up to 50 new user codes)
The User Code must be a 4-8 digit combination. Each User Code is then linked
to a User ID (which is any number between 01-50) to identify an individual User ID
Code . (User ID 1-9 should be entered as 01-09 so they are 2 digits).
UC
For example: to add the User ID - 08 to User Code - 5678, enter the following:
PC
123456
Hear 1 beep and Light Indicator illuminates green.
NOTE: When a NEW USER CODE is set, the default factory code (1234) is deleted
for safety.
Record New and Changed Codes on Programming Record located on Page 13.
PC
4 new Re-enter
UC
ID
1 Re-enter
ID
08
PC
PC
UC
5678 5678
PC
PC
UC
UC
Page 8