Consumer Friendly Message Guide / Programming Record - Honeywell 8712009 Installation & Operation Manual

CONSUMER FRIENDLY MESSAGE GUIDE
Unlock / Valid programming:
Lock:
Invalid Programming:
Low Voltage:
Super Low Voltage:
4 Incorrect code entry attempts:
Power on:
Chip Reset:
Lock Error:
Repeat operation after Lock Error:
NOTE: When battery is under low voltage, the lock will give the (Low Battery Warning: Beeps and
LED flashes red for 5 seconds). During this time your lock can still work. However once the voltage
is lower than 4.3V (called Super-Low Voltage), the operation of the locking and unlocking will not
work, user must replace batteries immediately.
PROGRAMMING RECORD
My Codes:
Programming Code
User Code 01
User Code 02
User Code 03
User Code 04
User Code 05
User Code 06
User Code 07
User Code 08
User Code 09
User Code 10
1 long beep and LED illuminates green
2 short beeps and LED illuminates red
2 short beeps and LED flashes red twice
Beeps for 5 seconds
(7/9 times depends on operation is unlock/lock)
4 short beeps and LED flashes red four times
2 short beeps and LED illuminates red each attempt
1 long beep and 1 short beep and LED illuminates green
1 long beep and 1 short beep and LED illuminates green
(may occur several times or once in a while)
3 long beeps LED flashes red three times
2 short beeps three times LED flashes red six times
Date Created
(6 digits)
(4-8 digits)
(4-8 digits)
(4-8 digits)
(4-8 digits)
(4-8 digits)
(4-8 digits)
(4-8 digits)
(4-8 digits)
(4-8 digits)
(4-8 digits)
/ /
/ /
/ /
/ /
/ /
/ /
/ /
/ /
/ /
/ /
/ /
Page 13