Cisco MDS 9000 Series Configuration Manual page 233

Configuring FC-SP and DHCHAP
Switch N DHCHAP
Modes
on
auto-active
auto-passive
off
Configuring the DHCHAP Mode
To configure the DHCHAP mode for a particular interface, follow these steps:
Procedure
Step 1 switch# configure terminal
Enters configuration mode.
Step 2 switch(config)# interface fc2/1-3
switch(config-if)#
Selects a range of interfaces and enters the interface configuration submode.
Step 3
switch(config-if)# fcsp on
Sets the DHCHAP mode for the selected interfaces to be in the on state.
Step 4 switch(config-if)# no fcsp on
(Optional) Reverts to the factory default of auto-passive for these three interfaces.
Step 5
switch(config-if)# fcsp auto-active 0
Changes the DHCHAP authentication mode for the selected interfaces to auto-active. Zero (0) indicates that
the port does not perform reauthentication.
Step 6
switch(config-if)# fcsp auto-active 120
Changes the DHCHAP authentication mode to auto-active for the selected interfaces and enables
reauthentication every two hours (120 minutes) after the initial authentication.
Step 7 switch(config-if)# fcsp auto-active
Changes the DHCHAP authentication mode to auto-active for the selected interfaces. Reauthentication is
disabled (default).
Switch 1 DHCHAP Modes
FC-SP FC-SP
authentication is authentication is
performed. performed.
FC-SP authentication is not performed.
Link is brought
down.
Cisco MDS 9000 Series Security Configuration Guide, Release 8.x
Configuring the DHCHAP Mode
FC-SP Link is brought
authentication is down.
performed.
FC-SP
authentication is not
FC-SP
performed.
authentication is not
performed.
215