Cisco MDS 9000 Series Configuration Manual page 195

Configuring IPSec Network Security
Enabling IKE
To enable IKE, follow these steps:
Procedure
Step 1 switch# configure terminal
switch(config)#
Enters configuration mode.
Step 2
switch(config)# feature crypto ike
Enables the IKE feature.
Step 3 switch(config)# no feature crypto ike
(Optional) Disables (default) the IKE feature.
Note
About the IKE Domain
You must apply the IKE configuration to an IPsec domain to allow traffic to reach the supervisor module in
the local switch. Fabric Manager sets the IPsec domain automatically when you configure IKE.
Configuring the IKE Domain
You must apply the IKE configurations to an IPsec domain to allow traffic to reach the supervisor module in
the local switch.
To configure the IPsec domain, follow these steps:
Procedure
Step 1 switch# configure terminal
switch(config)#
Enters configuration mode.
Step 2
switch(config)# crypto ike domain ipsec
switch(config-ike-ipsec)#
Allows IKE configurations for IPsec domains.
You must disable IPsec before you can disable the IKE feature.
Cisco MDS 9000 Series Security Configuration Guide, Release 8.x
Enabling IKE
177