Open Ip Ports On Cisco Mds 9000 Series Platforms - Cisco MDS 9000 Series Configuration Manual

Open IP Ports on Cisco MDS 9000 Series Platforms

Use the show interface command to display the IPv6-ACL configuration on an interface.
switch# show interface gigabitethernet 2/1
GigabitEthernet2/1 is up
Hardware is GigabitEthernet, address is 000e.38c6.28b0
Internet address is 10.1.1.10/24
MTU 1500 bytes
Port mode is IPS
Speed is 1 Gbps
Beacon is turned off
Auto-Negotiation is turned on
ip access-group RestrictMgmt
5 minutes input rate 1208 bits/sec, 151 bytes/sec, 2 frames/sec
5 minutes output rate 80 bits/sec, 10 bytes/sec, 0 frames/sec
6232 packets input, 400990 bytes
0 multicast frames, 0 compressed
0 input errors, 0 frame, 0 overrun 0 fifo
503 packets output, 27054 bytes, 0 underruns
0 output errors, 0 collisions, 0 fifo
0 carrier errors
Open IP Ports on Cisco MDS 9000 Series Platforms
Cisco MDS 9000 Series platforms with default configurations have IP ports that are open on the external
management interface. The table below lists the open ports and their corresponding services:
Table 10: Open IP Ports on Cisco MDS 9000 Series Platforms
Port number
None
600 - 1024
2002
7546
9333
Cisco MDS 9000 Series Security Configuration Guide, Release 8.x
114
Address is e8ed.f3e5.d28f
MTU 1500 bytes, BW 1000 Mbps full Duplex
5144246 packets input, 1008534481 bytes
2471254 multicast frames, 0 compressed
0 input errors, 0 frame
0 overrun, 0 fifo
1765722 packets output, 1571361034 bytes
0 underruns, 0 output errors
0 collisions, 0 fifo
0 carrier errors
IP Protocol Platform
(UDP/TCP)
UDP All
TCP All
TCP All
TCP All
TCP All
Configuring IPv4 and IPv6 Access Control Lists
Feature/Service Name Random Port?
— —
NFS Yes
Remote Packet Capture No
CFS over IPv4 No
Cluster No