Specifications - Makita TW0200 Instruction Manual

ENGLISH (Original instructions)
1-1. Switch trigger
2-1. Reversing switch lever
3-1. Socket
3-2. Anvil

SPECIFICATIONS

Capacities
No load speed (min
Impacts per minute
Max. fastening torque
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for fastening bolts and nuts.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
Noise
The typical A-weighted
according to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB (A)
Wear ear protection
Vibration
The vibration total
determined according to EN60745:
Work mode : impact tightening of fasteners of the
maximum capacity of the tool
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
Explanation of general view
4-1. Socket
4-2. O-ring
4-3. Pin
5-1. Hook
Model
Standard bolt
High tensile bolt
Square drive
-1
)
Overall length
Net weight
Safety class
noise level determined
) : 93 dB (A)
pA
) : 104 dB (A)
WA
value (tri-axial vector
2
) : 8.5 m/s
h
2
ENE036-1
WARNING:
The vibration emission during actual use of the
•
ENF002-1
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
ENG102-3
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
We Makita
manufacturer declare that the following Makita
ENG205-2
machine(s):
Designation of Machine:
sum)
Impact Wrench
Model No./ Type: TW0200
are of series production and
Conforms to the following European Directives:
98/37/EC until 28th December 2009 and then with
2006/42/EC from 29th December 2009
ENG901-1
And are manufactured in accordance with the following
standards or standardised documents:
EN60745
3
7-1. Limit mark
8-1. Brush holder cap
8-2. Screwdriver
TW0200
M10 - M16
10 mm - 12 mm
12.7 mm
0 - 2,200
0 - 2,200
200 N.m
251 mm
2.2 kg
/II
Corporation as the
ENH101-13
responsible