Lubrication - Grizzly G0854 Owner's Manual

Lubrication

To reduce risk of shock,
accidental
injury, always disconnect
machine from power and
air
maintenance, or service.
NOTICE
The recommended lubrication is based
on light-to-medium usage. Keeping in
mind that lubrication helps to protect the
value and operation of the machine, these
lubrication tasks may need to be performed
more frequently than recommended here,
depending on usage.
Failure to follow reasonable lubrication
practices as instructed in this manual
could lead to premature failure of machine
components and will void the warranty.
T26685—ISO 32 Moly-D Machine Oil, 1 gal.
T26419—Syn-o-Gen® High-Speed Bearing
Grease
T26685
Figure 64. ISO 32 machine oil and high-speed
bearing grease.
-44-
startup, and
before adjustments,
T26419
Glue Spindle
Lube Type ............ T26419 or NLGI#2 Equivalent
Lube Amount ..................................... As Needed
Lube Frequency ........................ 30 Hours of Use
Item(s) Needed:
Grease Gun ....................................................... 1
Shop Rags ......................................... As Needed
The glue spindle requires lubrication every 30
hours of operation to ensure smooth operation
and prevent premature failure. It is lubricated by
a grease fitting on the back of the machine (see
Figure 65). To lubricate the glue spindle, wipe
grease fitting clean and use a grease gun to pump
a small amount of grease into fitting, then wipe
away any excess grease with a rag.
Figure 65. Location of glue spindle grease
fitting.
Model G0854 (Mfd. Since 08/18)
Lubricating Glue Spindle
Qty
Glue Spindle
Grease Fitting