Makita DVC261 Instruction Manual page 10

Supplied Hose end type
hose
diameter
ø38 mm
with snap-on part
with front cuff 38
NOTE: Always use a suitable front cuff. When using
the front cuff 24, attach it to the front cuff 22 that is
connected to the hose.
1
► 1 . Front cuff 22 2. Front cuff 24
When using ø28 mm dust extraction
hose
1. Attach the front cuff to the hose for dust extraction.
When connecting the front cuff, make sure that it is
securely screwed on the hose.
Action
Replace the hose with the one
for dust extraction (ø28 mm,
with front cuff).
Attach the joint 22-38 or the
front cuff 24.
2
2. Connect the front cuff to the tool's extraction outlet.
3
► 1 . Front cuff 2. Extraction outlet 3. Hose
The front cuff can be detached by turning it counter-
clockwise while holding the hose.
When using ø38 mm hose with front cuff 38
1. Twist and insert the joint or the front cuff to the inlet part on
the hose, depending on the tool that you are going to connect.
2. Connect the front cuff to the tool's extraction outlet.
4
► 1 . Joint 2. Front cuff 3. Extraction outlet 4. Hose
To remove the joint and the front cuff, follow the installa-
tion procedures in reverse.
10 ENGLISH
1
2
1
3
1
2